Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rahul v sangani
EPBX is "Electronic Private Branch Exchange" which is used
by many organisation to transfer more than two to three
lines to various extensions
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
What do you mean by passive circuit elements and why these are called passive?
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
How to calculate that clean water supply in one Day from 150 KLD STP?
Why High voltage are generate noise ?
what is mean by descripiency relay? & wht is its ansi code?
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
How to calculate VCB rating for 33KV ,25 MW Power line?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Why reactors use before incoming of ac vvfd drive?
how much LT load can bear by the 100 KW HT connection.
what is the importance of earthing system on the generators big capacity and small?
how to calculate single phase motor efficiency ?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
