Answer Posted / gopal prasad
Fuse is an device used to protrct the wireing,in case of
over current,short circuit conditions.When this type of
fault occurs in a system or failure of insulation, maximum
fault current flows in wire.If fuse is connected to the
neutal:
(i) fuse will not blow when phase is shorting with
earth line and cause fire hazard.
(ii)if fuse is blown off then also phase supply
(live)will be available which wilb dangerace for the peson
thinking that no power is available to the equipment.
| Is This Answer Correct ? | 22 Yes | 5 No |
Post New Answer View All Answers
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
how to find the torque of the single phase synchronous motor by doing an experiment
Define noise?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.
What is boucholz relay and the significance of it in to the trformer?
what is a power factor?
how to calculate units consumption for a 12 hp motor /hr.
how to decide choke rating for drive?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
What is the function of RCBO? What are the different sensitivity ratings & each application?
what is different between relay and plc?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
