Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / m_anwar
AVR stands for Automatic Voltage Regulator.
So it is a regulating system which measure the generator
output then comparise with a reference value and generate a
positive or negative output to the excitation system to
decrease or increase the excitation to increase or decrease
the generator output voltage.
| Is This Answer Correct ? | 40 Yes | 4 No |
Post New Answer View All Answers
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
What is a copper loss or i2r loss pc?
What are the basic elements used for modeling mechanical rotational system?
how you configure motorvision relay (L&T make)from DCS
why 1.7Uo for HV cable Hi pot test?IE standard why?
what is the total power generation in india?
what is gas turbine intercooling ?
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
how we explain parallel paths armature winding?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
Why front mounted CT polarities are always towards breaker?
