In an airframe assembly,whats the use of STRESS ANALYSIS
being conducted on newly designed component or modified
component...?
- 4 Answers
- 7311 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh
While making a metallic component or while modifying them
an internal stress will be caused due to drilling,
riveting, hammering, shaving, milling or any similar
actions. This internal stress sometimes may exceed the
yield strength of the metal, so annealing (reheating and
slow cooling) is carried out to release the internal stress
in the component to avoid fracture. This is a process of a
stress analysis .
In simple words
this stress analysis is carried out to avoid the the
material to break by itself.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
Is it possible to open flight door at high altitude?
What operational benefits do hydraulic actuator/rate controls have over gas charged units?
If you have a fuel valve with a pressure applied, what is the stress to the open and closed valve?
You are about to take off the plane in few seconds and a catastrophic engine fails, and your captain tells you not to take off and just stay in the center line
Explain RAID and mirroring?
what do you mean by stalling of aircraft?
What are the measures taken to save the aircraft from lightning?
While flying, what you should do in an emergency?
Explain the day to day responsibilities of aerospace engineering?
Can a carbon dioxide gas use as fuel source?
Explain the use of radar.
What are the different phases of aircraft design?
Why you would like to join the aviation industry?
What is Jet Lag?
When a pilot is assigned a speed, how much can one deviate from that speed?
