Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / thowsif_csm team_emerson
High Frequency Grounds to reduce or eliminate high
frequency transients by achieving
a common ground reference for all equipment within a
contiguous area.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
A cotter joint is generally used to transmit
why we cannot protect 100% winding of an alternator by using differential protection?
what are the basic insulation levels & what its Unit
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
why there using acb enclosure in big buildings
how to design the heater in temperature control unit to heat 50KL of water?
What is the exact formula for one weber of magnetic flux?
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
What is the tension required for the 25000 CFM AHU belt
How to calculate Temp from Resister from PT100 equation,
