Interested to Buy Any Domain ? << Click Here >> for more details...
If you see the HRC fuse name plate. Its shown ampere rating
shown which is in many KA (like 80KA and so on). any body
explain what is meaning of this value?
- 7 Answers
- 18867 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin sarda
Thanks for reply...but i have little confusion on same.
Because in a fuse plate shows two types of ampere rating.
one is in only in amperes (like 100Amp fuse) and second,
shows in Kilo amperes (like 80KA on same fuse). then what
is meaning of 100A and what is the meaning of 80KA. Both
are written on same fuse.
If considered above answer, KA shows short ckt capacity
then Ampere reading of fuse what will show??
Please explain in details
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
how to compute kAIC? with formulas...
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
witch pump used in wtp
What is primary and backup protection?
What is meant by analogous system?
Which power will flow first if we switch on a motor Active or Reactive? How?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
Discuss the effect of sudden loading of an induction motor
how to design coil turns ?
What are the essential characteristics of signal flow graphs?
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
how we provide neutral earth on synchronising panel as per electrical standards?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
