Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use vestigial side band (VSB-C3F) transmission for
picture?
- 16 Answers
- 68359 Views
- BPL, I also Faced
- E-Mail Answers
Answer Posted / ajivadakkedathu
VSB transmission reduces bandwidth of the transmitted
signal. Since it is very difficult to separate carrier at
the receiver (video frequency range - 0 to 5MHz), distortion
may occur to low frequency components in the spectrum.
Because of this, a portion of LSB is also transmitted.
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
What is the between demultiplexer and decoder?
Distinguish between jfet and mosfet.
explain with a suitable diagram how a vidicon pick-up tube is employed in a monochrome TV camera to develop luminance signal
In order to handle all combinations of input voltage polarities, a multiplier must have A Four-quadrant capability B Three- quadrant capability C Four inputs D Dual-supply voltages
hi i am electronics & telecomm engg & appling 4 the AAI jr executive (electronics/ATC) written test. pls forward me the syllabus & old question papers.I will be very much thankful to you. pis inform to
# What is D-FF? # What is the basic difference between Latches and Flip flops? # What is a multiplexer? # How can you convert an SR Flip-flop to a JK Flip-flop? # How can you convert an JK Flip-flop to a D Flip-flop? # What is Race-around problem? How can you rectify it?
wat power transmitter we use in radar n explain its principle??
which are the five general EMI(electromagnetic interference) testings conducted on any system?
Explain what is difference between fixed-bias circuit & self-bias circuit?
Please send RRB section engineer's signal paper of past 20 years.This is very urgent.I am giving section engineer exam this syear
please send me the previous question papers of ntpc writen test for ece
Explain we take the area of collector wide comparison to base and emitter. Why?
Explain the operation of multistage control of ac voltage controllers with neat diagram?
The number of columns in a state table for a sequential circuit with m flip-flops and n inputs is
Explain what is the difference between plc and dcs?
