Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / selvakumar
DPT is give the output of difference of the HP and LP.
Process line Upstream side is connected to the HP side(P2)
of the transmitter. Downstream side is connected to the LP
side(P1) of the transmitter. Output will come like this
(P2-P1). Q = k (Root of Delta P). Delta P = P2-P1.k =
constant.
Onemore type is there. Diapharm type it is also working as
well as DPT. But Silicon oil is filledup the inside of the
cabbilary. This oil will push the diapharm of the
transmitter, then resistance value will change,
corresponding to the input pressure.Corresponding the mA
will converted by transmitter.
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
How process line mpm calculation is done?
How to find out the current of two motors having same power consumption but different RPM?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
please send the sample qustion paper for iocl written test ..
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
what is the process for double acting cylinder pneumatic for 32' v/v
There are many type of control cable like pair,core,tried, What are defination each one
how to commission furnace ( water heater)
which type inter lock use in petrochemical refinery,and oil & gas?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
What are different types of orifice plates?
What is loop1 and loop2 in MTS LT?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
where proximity sensor installed on tank in loading arm application
