Interested to Buy Any Domain ? << Click Here >> for more details...
How do we MEASURE OR CALCULATE VELOCITY used to calculate
REYNOLDS NUMBER??
- 3 Answers
- 8804 Views
- I also Faced
- E-Mail Answers
Answer Posted / monu
row d v/ myu
where myu is viscosity d = dnsity and v= velocity that
eqation gives reynolds number.......moreover if reynolds
number is high .....fluid is a good one with low
conductivity and low viscosity
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
What is 3 selection available when configure the burnout protection for controller
what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration
Square root calculation for dp flow transmitter?
Differentiate between ultrasonic flowmeter and radar type flow meter
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
Pl send the model question paper of mahagenco account officer post
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Manipulation of dead wt. tester double piston type.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
Why humidity limit is 30 to 55 % for raw material storage?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
