Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / thowsif_emerson_csm team
Apparent power is the combined power value that is obtained
by allowing for the different values of current and
voltage. Essentially, the measure of apparent power is
achieved by multiplying the applied voltage to the current
generated. Most electrical systems operate by the use of
apparent power.
There are a few basic understandings about the nature of
apparent power that help to define the nature of the power.
Components of both reactive and real power must be present
in order for apparent power to exist. That is, the load
must be both reactive and resistant in order for the flow
of apparent power to take place, and thus create a means
for measuring the nature of the generated power. In
addition to the presence of resistant and reactive loads,
it is also important to determine the watts involved in the
current as well. Just as in determining the rate of any
complex power, knowing the watt value is key to
understanding the nature of apparent power.
In the actual calculation of apparent power, the number of
volts is multiplied by the number of amps. Results of the
calculation are presented in terms of volt-amperes reactive
and real power. This simple multiplication of voltage and
current makes it possible to ensure that the flow of
apparent power is sufficient to operate devices designed
for a given level of power, as well as ensure the flow of
apparent power can be handled by the components within the
device. Within this context, the measure of apparent power
is very important to manufacturers, as it allows them to
ensure that all products are within the standards
applicable within the jurisdiction.
Measuring the flow of apparent power is also critical in
the tasks of wiring public buildings and residences
properly. Plants must ensure that all electrical wiring and
additional components will adequately support the power
supply needed to drive large machinery without overloading
the circuits or wiring systems. Power suppliers themselves
will measure apparent power to make sure that the flow of
harnessed energy into homes and other buildings is
maintained within the safety standards that apply to the
area and type of structure.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
how to apply b license to c license in tneb
how we can calculate chiller required ampear?
how can decide the current rating of oltc
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
What is the previous name of Cox's Bazar
What is the ratio of Booster transformer?
What is the comparison of PILC and XLPE cable
How to calculate Temp from Resister from PT100 equation,
what is the effect of un-synchronized power.
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
