What is the deff betwen Two stroke engine & Four stroke
engines. Difine Theoretcally & Practically.
- 11 Answers
- 13753 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhim
Theoriticlly 4 stroke engine thermal efficiency is more nd
for 2 stroke it is less
cycle completed in 2 revolutions for 4 stroke, 1 revolution
in 3 stroke.
Prctically the cost of the 2 stroke is less and the design
is robust compared to 4 stroke as it has ports instead of
valve mechanism. and the wear and tear is more in 2 stroke
compred to 4 stroke.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is blading efficiency of steam turbines ?
What is extrued aluminum?
What are the causes of boiler backfire and steps in how to prevent it from happening?
If a dimension is given as SC parameter, is supplier allowed to use full range of tolerance specified in drawing without proving capability?
"What do you going to observe, when a diesel engine is running?"
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
1.how do you purchase the sheetmetal,machined components for OEMS? 2.WHAT IS THE SYSTEM TO BE MAINTAINE FOR PURCHASE ACTIVITY? 3.HOW DO U DO THE PRICE NEGOTIATIONS & ITS PROCEDURES? 4.WHAT ARE THE PROBLEMS WILL FACE WHILE PURCHASING THE COMPONENTS& WHAT IS THE SOLUTION TO OVERCOME BY THAT ONE 5.WHAT IS THE NECESSARY NOTES TO MAINTAIN THE PO& RELEASING THE PO?
[lease send recent question papers of rrb in junior engineer
While finding the velocity of gear B , in case of a simple epicyclic gear train, why do we take tke velocity of gear A to be ZERO(0)if the arm is rotated with speed equal to that of gear A and in opposite direction?
How would you increase the volume efficiency of centrifugal pump?
Explain about front drive mechanism in vehicle
What is short cycling in refrigeration system?
What is the profile of QA engineer
DIFFRENCE BETWEEN ISO AND TS
What is the purpose of increasing the pressure on the F.O. system of the engine?
