IF 3 NOS.OF HEATERS,3KW CAPACITY EACH,1 NO.HEATER CONNECTED
IN R PHASE,1 IN Y PHASE AND 1 IN B PHASE.THEIR END POINTS
CONNECTED IN STAR.IF I CONNECT THIS STAR POINT TO NEUTRAL
OR DO NOT CONNECT TO NEUTRAL.WHAT WILL THE DIFFERENCE.
Answer Posted / vijay chander
if you connect star point with ne circuit will close
otherwise it not close
Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
whether fibre optic cable in high voltage earth conductor is used for protection circuits
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
what is High resistance grounding and whatis the criteria for the selection of High resistance grounding
how much LT load can bear by the 100 KW HT connection.
How to decide and select the different earthing wire size for the different types of earthing
what is the concept of directional power?
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
what is control supply rating of a machine
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what purpose to use excaiter in DG.?
what is the difference between circular wdg & ractangular wdg?
what is difference between 5A and 100A CT constructional wise and operation?
How to measure current and voltage in an ELV circuit
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?