Interested to Buy Any Domain ? << Click Here >> for more details...
please mention the minimum IR value for different voltage
systems
- 6 Answers
- 8796 Views
- I also Faced
- E-Mail Answers
Answer Posted / bharathi
for 415 voltage miniman 50 mega ohm dep upon tamprature
| Is This Answer Correct ? | 1 Yes | 8 No |
Post New Answer View All Answers
How to design harmonic filter at the project stage without nowing the harmonics levels
I completed iti in2004 I was worked in A grade contractor can I get c licence
What is the working principle of MIG welding? and its out put Voltage?
how to extend relay operating timing in 24V dc relay card (without using Timer )
Please elaborate th´evenin’s theorem?
howmany electrician should maintain for a 1000 kva used plant... in kerala..
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
What is the RME and explain the full form and what is the RME work?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
how generator load test is conducted?what are the steps?
gas turbine genrator reactances
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
Why HT 11 KV Slipring Motors are connected in star ?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
