why we are used D.c. voltage in L.T.side or controling
side.we can use UPS also ,in place d.c. voltage
- 5 Answers
- 7286 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rajesh vania
Gangadhar say
absolutly right
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
why is control bus bi-directional?
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
How to operate a ac chilar plant?
Is neutral transformer can be called as control transformer?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What is the use for cable entry in control room?
What are the operation carried out in thermal power station?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
can you plz send l&t aptitude questions if available its urgent plz plz plz
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
What is step signal?
what is star delta starter? how it works? give its control and power diagram.
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
