Interested to Buy Any Domain ? << Click Here >> for more details...
Why semi-conducting insulation is used in XLPE cables?
- 1 Answers
- 4931 Views
- I also Faced
- E-Mail Answers
Answer Posted / jyotirmaya
To discharge the leakage current produce in the cable.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
Name the component u would expect to find in a switchgear assembly?
How will be the single line diagram of series trip HT breaker? how it works?
what is meant by carrier aided trip protection in transmission line
Define resonant frequency?
How to calculate impedance volt in Transformer?
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
What is difference between Sample test and Routine test in safety standard?
What is the capacitance values of 132,220,400 & 765 kV current transformer
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
IF DISTANCE IS 100METERS B/W AMP.METER AND CURRENT TRANSFORMER WHAT WILL BE AFFECT IN ACCURACY .METER CAN SHOWING ACCURATE CURRENT OR NOT IF NOT WHAT CAN I DO TO GET 100% ACCURACY.
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
