Interested to Buy Any Domain ? << Click Here >> for more details...
what is need of air gap in expansion section in busbar?
- 3 Answers
- 6553 Views
- I also Faced
- E-Mail Answers
Answer Posted / venu
Dear sir (Anto)
dont misleed the question many yuongsters are going
through this site
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the current setting for different relay protection for transformer .
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
HOW TO CALCULATE EARTHING SIZING?
why chock were used in old tubelights but are not newest tubelights?
66kv under ground cable how to layaing in ground any special case two ckt r runing
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
What will happend if given Vfd out put to step up transformer
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
what irequirment need to be followed when working on live equipment
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
how freewheeling diode improves the powerfactor
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
Lt motor sfu flashing reasons?
