please mention the minimum IR value for different voltage
systems
Answer Posted / karthik raman.b
for high voltage 1 mega ohm and for medium voltage 500 ohms
| Is This Answer Correct ? | 3 Yes | 8 No |
Post New Answer View All Answers
XYZ
Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
What Is HO factor in power selection
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
in what type of applications v can use q meter?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
What are n circles?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
direction of tarbine& genrator