Answer Posted / karthik raman.b
basically motors are used to drive a load its like a horse power horse can drive 75kg load in 1 sec in 1 meter like this a motor can do
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is difference between start imitation and start interlock for 3 phase motor protection ?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
1 hp is equal to how much watt?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
How servo stabilizer works.
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
What is the lower limit of break-down voltage of converter transformer.
What is transient response?
why current is constant on d.c?
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
What type of pipe material G.I or M.S is used for sprinkler system?
What will be result if we connect LT votage to the terminal of HT motor?