Interested to Buy Any Domain ? << Click Here >> for more details...
Can someone give a detailed chart on the temperature ranges
which can be measured by various temperature sensors.
- 3 Answers
- 5591 Views
- I also Faced
- E-Mail Answers
Answer Posted / ulaganathan
generall for the measurement of low temperature
range is by using thermistor
and for higher order terms i.e>1300 c we are in
use of thermocouple
greater than that temperature we are in use of
pyrometers
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is function of sensor, and how is it work , explain with difination
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
Whatis the reset ofset and control system in instrumentation
what is scale factor of proximitor & unit of the vibration.
What is difference between differential pressure & delta pressure?
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
What is the use of control cable?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
What is hp & mp seperator .& what is its working principle ?
what is function of SCADA , and how is it work, explain with difination
i am having information technology branh ....... can i prepare for psu exam
What is the differerence between hysterisis and linearity.
How to Calibrate Flammable gas detector in field
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
