Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ankur jain
all the neutral wires are conneceted to a single point and
that is connected to deep inside the earth, this is called
earthing , done to protect the equipments from high fault
currents.
| Is This Answer Correct ? | 9 Yes | 8 No |
Post New Answer View All Answers
distribution is maximum done by a)radial b)network c) parallel d)b & c
How will polarity test of Dy5 Transformer ?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
how to work droop ct in generating station
Starting current of a 10 HP induction Motor is ______ time’s full load current.
Draw a SLD of DG distribution up to main LT panel?
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
What is the function of capacitor in electrical circuits?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
why genarator genarating voltage 11 KV?
why is control bus bi-directional?
Why synchronous motor is used in power factor improvement,dc series in lift
brief notes on ammeters
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
