Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between RS 232,RS 485,RS 422, how
they different from each other
- 15 Answers
- 46384 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / ankush agrawal
RS 232--PPI(point to point interface/2 nodes)
RS 485--MPI(maximum point interface/32nodes or more)
RS 422--MPI(MAXIMUM POINT INTERFACE/10NODES)
ADVATAGE OF RS485 over RS232
high distance (4000 Feet)
high noise immunity
No of nodes is high
there is no difference in terms of speed in the RS232 and
rS485
| Is This Answer Correct ? | 29 Yes | 6 No |
Post New Answer View All Answers
What are different types of cable?
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
how do u calibrate the vacuum transmitter if it shows more reading
all questions related to instrument technician in any offshore oil and gas company.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
What is the difference between modbus,fieldbus & profibus
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
Why grounding is necessary? Give example with diagram.
Gas equation
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
Difference between dcs and plc including date processing and architecture.
Which type of pressure can be measured by primary elements?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
