Interested to Buy Any Domain ? << Click Here >> for more details...
working of a diesel generator.
- 34 Answers
- 180358 Views
- ABC, AC, Cognizant, CTS, Directorate of Lighthouses and Lightships, KSL, Quippo, Shree Renuka Sugars, SRF, Svam Power, Tech Mahindra, I also Faced
- E-Mail Answers
Answer Posted / kumar
generator is mechanical energy to convert electrical energy
using alternetor
| Is This Answer Correct ? | 30 Yes | 6 No |
Post New Answer View All Answers
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
What is the type of earth fault protection used in battery? explain.
In a flange coupling, the flange bolts are designed for
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
upto how many load can v connect to stabilizer which is used for tv
What the difference between ac and dc inductor an capacitor
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
