Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mohit
WHEN WE USED 220 50 HZ SUPPLY WE CAN USE THIN ELECTRICAL
WIRES BUT FOR 120V 60 HZ SUPPLY WE NEED THICK WIRES.RICH
COUNTRU CAN PAY FOR 120V 60HZ AND SHOCK RATE IN CASE OF
120V IS LESS THAN 220V .HENCE FOR PERSONAL SAFETY REASONS
AND RICH , US. ETC ARE USING 220C 50HZ SUPPLY.
| Is This Answer Correct ? | 27 Yes | 10 No |
Post New Answer View All Answers
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
draw 3 phase rectifier diagram
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
what are the possible reaons & remedies if resistance of NGR getting heat up
132/66kv sub-station procation ?
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
What is the function of capacitor in electrical circuits?
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
why is control bus bi-directional?
what material is the electrical housing wire made of? is there any difference for the telephone lines?
relation between power station capacity and voltage level?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
what is difference between line differential and transformer differential?
