Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use the D-curve MCBs in critical power distrubution.
- 4 Answers
- 8326 Views
- Sodexo, I also Faced
- E-Mail Answers
Answer Posted / thowsif_emerson_csm team
Hi Venkat Iyer
Can u pls tell me what is A,B,C,D Curves in MCB's...
My mail id is jswblrdc.support@jsw.in
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
Why is a synchronous motor always star connected??
is that any software calculator to calculate the size of cable
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
what is d check in dg 1500kva
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
how can get electrical "c" licence.i am complited in DEEE.PASSING YEAR OF 1993.WORKING IN PVT COCERN LT LINE.PLEASE ADVISE ME .CELL NO 9994786021
use of choke in APFC panels
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
