Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use 250 ohm resistor in series with HART protocol
communication?
- 13 Answers
- 58774 Views
- Chemtrols, Instec, Sabic, I also Faced
- E-Mail Answers
Answer Posted / abel002
Becoz DCS is given the signal in terms of voltage(1 TO 5 V).
And V=IR,
Now Whwn I=4ma
V Should be 1 V
putting in V=IR we get r=250 ohms.
Same in case when I=20 ma
and V=5V WE GET r=250 ohms.
| Is This Answer Correct ? | 31 Yes | 14 No |
Post New Answer View All Answers
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
what is the imbustion control loop
Whatis the reset ofset and control system in instrumentation
In turbine what does term CDP, NI, NH, HSSOC means.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
What is difference between differential pressure & delta pressure?
Draw block digram for well head from well to shipping pump?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
Make Heater Process Logic.
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
Explain bernoulli’s theorem. State its application.
