Interested to Buy Any Domain ? << Click Here >> for more details...
Can anyone say that formula of Converting the Diff.
Pressure into Flow in Kg/Cm2 or any explaniation of Orifice
Plate, Beta Ratio , How to calculate
- 1 Answers
- 8288 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajkumar
The basic formulas for determining the flows are as follows:
V = k*sqrt(h/p)
Q = k*A*sqrt(h/p)
W = k*A*sqrt(h*p)
Where:
V = Velocity
Q = Volumetric flow rate
W = Mass flow rate
A = Cross-sectional area of the pipe
h = Differential pressure between points of measurement
ρ = the density of the flowing fluid
k = a constant that includes the ratio of cross-sectional
area of pipe to cross-sectional area of nozzle or other
restriction, units of measurement, correction factors, and
so on, depending on the specific type of head meter.
If you gather the outstanding data and use the above
mentioned formulas - you will be able to calculate your flow
rate.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
In apron feeder how TPH is calculated?
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
How digital input and digital output 's are working in dcs
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
kindly sent some demo question and answer
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
why is an oxygen sensor used in a boiler stack
what is function of SCADA , and how is it work, explain with difination
how to relay switch sense the fault?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
