Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / hasan mehdi
For PID controller the actuating signal consists of
proportional error signal added with derivative and
integral of the error signal. There fore the actuating
signal for PID control is
ea (t)=e(t)+Td de(t)/dt + Kt}e(t)dt
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
which type inter lock use in petrochemical refinery,and oil & gas?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
Why ac supply load cell is used? Can we use the dc supply load cell?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
pls give me presant awerness quistion and answer in my emailid.
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
what is function of switch, and how is it work, explain with difination
where cascade loop use ?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
How servomotor controls throttle valve of TURBINE?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
what is the reset offset and control system in instrumentation
