Interested to Buy Any Domain ? << Click Here >> for more details...
What is the required bending radius requied at the time of
cable laying?
- 1 Answers
- 5023 Views
- I also Faced
- E-Mail Answers
Answer Posted / vknt
bending radius should be 12 to 15 times of the cable diameter.
for XLPE cable 12 times of dia.
for PILC cable 15 times of dia.
| Is This Answer Correct ? | 11 Yes | 5 No |
Post New Answer View All Answers
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
How many types of faults are there in 3 phase power system?
Why need 3phase machine double earthing?
what should be correct gas pressures to be a 1.5 ac unite
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
my diploma certificate in my higher education college
What is meant by Low Resistance Cable and High Resistance Cable.
Why does the adjacent zone of protection overlap?
what is the usage of microcontroller in the panel board?
my b-tech percentage is 50%. what answer will satisfy the hr ?
What are the different types of dams?
I need model question papers for RRB section engineer Chennai... Please send to my E-mail Id:- maitheerainbow@gmail.com
How to calculate earth wire load by formula
What is the necessary condition for stability.
