Can anybody tell me why inductors draw lagging current and
capacitors draw leading current from supply?
- 4 Answers
- 8101 Views
- I also Faced
- E-Mail Answers
Answer Posted / md
lets we start with resistor in which voltage and current
are in same phase means when voltage attains its peak at
the same time current attains its peak but when it is
passed throuh inductor than rate of change of current is
opposed by inductor so when voltage attains its peak,
current is not able reach at peak at the same time but gets
delayed by some degree depends on inductance. in case of
capacitance rate of change of voltage is opposed by
capacitance but current can pass through it and than it
leads by some deg. depent on capacitance.
| Is This Answer Correct ? | 36 Yes | 2 No |
Post New Answer View All Answers
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
Which device of PlC does share load between DG sets when DG are running in perallel?
which VFD is better ( LT or HT)
What is difference between Over Current & Earth Fault protection?
What is accuracy of a measurement?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?
how to get electrical supervisour certificate in gujarat
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
What is the necessary and sufficient condition for stability.
What is Scheme Test of High Voltage Switchgear. Which tests it includes.
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
