Interested to Buy Any Domain ? << Click Here >> for more details...
why earth hole size is biggest in plug point?
- 22 Answers
- 45705 Views
- Al Qabas, HCL, RRB, I also Faced
- E-Mail Answers
Answer Posted / azhar malek
the earth hole is big cause of the resistance if the hole
is small than res. will high and therefore we could not get
much better result, that's why it is kept bigger than phase
and neutral
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
How to determine alternating current frequency?
Which cable is use for rtcc control panel
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
What is lifting power for 1 wb/m2 and 1 A magnet?
how point on wave controller works.
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What is signal flow graph?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
Give two basic speed control scheme of dc shunt motor?
how to select the double earth conductor if 21A full load?
How is the connection of the tap changer on the HV side been made?
What is the maximum percentage voltage drop (vd%)for a motor control center
What is the necessary and sufficient condition for stability.
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
