What will happen if supply to three phase motor is given
wiyhout inerting rotor in it?How much current it will draw?
- 5 Answers
- 6302 Views
- I also Faced
- E-Mail Answers
Answer Posted / chitalima c christopher
To start with; A THREE PHASE INDUCTION MOTOR in operation
behaves just like a transformer except in a motor the rotor
is introduced, therefore a stator without a rotor will
behave just like a transformer on no load meaning it will
only draw a minimum excitation current which will be of
very small value
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Difference between transition and diffusion capacitance
List examples of current sources?
What are the types of transformers according to the arrangement of iron cores?
defination of controlled shunt reactor
What is a difference between indoor transformer and outdoor transformer of same rating
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
What Maximam Gap Taibaar & Bush
why 1.7Uo for HV cable Hi pot test?IE standard why?
Comment on the working principle of operation of a single-phase transformer.
Why is a synchronous motor always star connected??
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
What is s-domain and its significance?
why ct ,cvt should be stored in a vertical position?
What is the maximum and minimum rating of UPS?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
