Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN
ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii)
DELTA LOAD, USING A CLAMP METER.
NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO
WE GET?? PHASE CURRENT OR LINE CURRENT.
- 13 Answers
- 35913 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / thowsif
In Star System Line Current = Phase Current
In Delta System Line Current = Root 3 Times the Phase
Current.
It Only a Line Current not the Phase Current.
| Is This Answer Correct ? | 13 Yes | 2 No |
Post New Answer View All Answers
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
details of oil cell size of Breakdown voltage test of tranformer oil details as per Standardswith mushroom electrodes?
What is force on parallel conductors ?
What is the power factor of a transformer at no load?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
why we use copper earthing for neutral while for body GI.
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
how much LT load can bear by the 100 KW HT connection.
Explain RLC circuit?
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
how to control dc motor?
what is the difference between earthing and unearth
how to maintain frenquncy with syncronising sub-station for distribution
