Interested to Buy Any Domain ? << Click Here >> for more details...
a.)Ammeter and Voltmeter read rms value or avg. value ?
b.)What are symmetrical and Unsymmetrical faults?
- 2 Answers
- 7157 Views
- I also Faced
- E-Mail Answers
Answer Posted / denzel101
Ammeters and voltmeters read R.M.S values
Symmetrical faults are balance faults occuring in power
system. For a fault to be classified as symmetrical, all
three phases must draw equal fault currents and the phase
displacement must remain 120 degrees. examples
1. all phases shorted to each other.
2.all three phases shorted to earth.
Unsemmetrical faults occurs when one or two phases are
shorted to earth or two phases to each other.the faulty
phases will draw fault currents which are not equal in
magnitude with healthy phases and does not have 120 degree
phase displacement.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
i want to model paper for section engg.
Graphs of measuring power and speed on dc motor
How to setting the volume of RTCC panel AVR (11kv) controller
How many types of electric motors are there?
Sate maximum power transfer theorem?
what is mean by restructuring power system?
What happens if i apply 500V to 440V rotary Switch ?
What is meant by cold loop test in instrument
what is the use of Auto re-closer?
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
Explain Creepage Distance of Insulator
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
