Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mathan
German physicist GEORG OHM at 1987..the ohm law is V=IR.
V- Voltage in volt
I- Cirrent in amp
R- resistance in ohm
the ohm's law states that, voltage is equal to the current
times resistance.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
what effects a surging can produce in the compressor
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
what is function of switch, and how is it work, explain with difination
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
What is voltage regulator?
wich is coming the first HAZOP OR SIL
what is the protection system in solar turbine compressor
What is the use of double seated valve?
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
give me the formula for analog to digital converter and also d to a converter
What are the uses of orifice plates?
