Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / elangkumanan
150KW-500KW LOW VOLTAGE
500KW TO 11KV VOLTAGE TO HIGH VOLTAGE THAT IS DIFFERENT
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How PADO software increase the efficiency of power plant?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
What happens to voltage when current through the inductor is constant?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
which type of motor is used in automatic swing gate
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
What is phase cross over frequency?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
hey guys help me out.....what are the industrial uses/functions of nozzles in industries
What are the basic components of the feedback control system?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
