Interested to Buy Any Domain ? << Click Here >> for more details...
when a hand crancked meggar is used to check most three
phase induction motors, how many tests r rquired? Why?
- 1 Answers
- 4086 Views
- I also Faced
- E-Mail Answers
Answer Posted / balajieee
using meggar we will check it out insulation resistace
between each phase winding and body of the motor.then
insulation resistance between diff phases(R,Y,B).if the
resistance value is high and equal for each phase means the
motor winding is ok.in hand cracked meggar if u increase
speed means battery output supply also increasing.so if u
note the mega ohm value at high speed of meggar means u
will get accurate answer.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is deference between MCB & MCCB & ISOLATOR
What is the dependency of stiffness on load angle??
The synchronous machine excitation system explain
what is the formula for hv test for cable and circuit breaker..????
what are inherent currents?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
Is the theorem applicable to ac sources?
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
What do you mean by reach and reach the point of the relay?
What is an ac motor?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
What is the working principle of MIG welding? and its out put Voltage?
how to calculate the capacitor to maintain power factor?
