Interested to Buy Any Domain ? << Click Here >> for more details...
what can i do, if i want to carrier in design as i am
electrical engg?
- 3 Answers
- 6135 Views
- I also Faced
- E-Mail Answers
Answer Posted / jayashree
Dear Raskar Sir,
I am too an Electrical Engineer having 5 years experience in
control panel division as Costing cum Design Engineer. My
job profile is preparing quotations, designing G.A.D, S.L.D
and power wiring diagrams. I want to learn to design control
wiring diagram. Is there any reference available for doing
control wiring dia.?
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Percentage losses in power generation?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
How efficiency of thermal plant can be improved?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
what are the breakdown voltage rating of mini- curcuit'transfarmer!
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
