What will happen if we give DC supply to AC motor?
- 9 Answers
- 34713 Views
- I also Faced
- E-Mail Answers
Answer Posted / rahul
of course it will not run..coz an AC motor(sync or ind)
needs rotating magnetic field which is possible to get only
if dc supply is rotating. Sync motor has arm on stator. So
no rotating field. And induction m/c run on Electromagnetic
induction principle which is not possible with dc coz ckt
saturates in dc(similar to transformer). So there can be
heavy heating followed by damage;
| Is This Answer Correct ? | 59 Yes | 3 No |
Post New Answer View All Answers
what is the difference b/w ATS and HTS?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
How to calculate ant test the burden of Current transformer
What does a Bode plot tell you?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
what is the affect of earth's magnetic field on the frequency used in aircraft???
What is conventional thermal current (Ith)
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
what is the function of anti pumping relays? what is KVAR? How it is generated in alternator? What is 3rd Harmonics? What is IDMT relay?
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
what is the relationship between phase & neutral
