Interested to Buy Any Domain ? << Click Here >> for more details...
why power is generatd at 50 hz only..?
can we do this on another freq...?
- 7 Answers
- 9631 Views
- I also Faced
- E-Mail Answers
Answer Posted / shivam
when we can do this, as u say, then why we dont do this.
because it is said that efficiency increases on increasing
frequency. plz help me out
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
what is saturation kit?which use above 15 kw motors panel side.
how is the incoming cable size calculated for a given current rating of a panel??
plz tel me syllabus and exam date 4 jr executive engg (electrical)
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
How energy is generated in hydroelectric power plant?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Iin ESP why positive is grounded ? why not negative ?
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
How can you sized or estimate the ligthning arrester current rating?
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
In the magnetic fluxes, what is the role of armature reaction?
Why let through energy not considered for ACB breaker while cable sizing?
What are stable systems?
can anyone tell me can the electromagnetic waves can be reflected back?if so how &by which material it can be reflected back?please tell me so that it can help to my wireless power trasnmission device.
