Answer Posted / siva
Diversity factor is the ratio of the sum of individual Max
demands to the Max demand on the power station. Diversity
factor is always greater than UNITY. The greater diversity
factor is lesser cost of generation of power.
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
what is difference between bus coupler and auto transfer switch
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
how to carried out DAR test in 11 KV Alternator ?
derive DC RMS value for half wave rectifier?
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
What is the formula to calculate the rating of a three phase miniature circuit breaker
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
can anybody sent me power grid questions. what subject should i prefer for preparation?
how ct burden,magnetising current,ratio and knee point voltage are related & derived
do we use neutral grounding for resistive balanced load? if we use what happen?
Tell me all plants load factors i.e which plant operating on which load?
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
