Interested to Buy Any Domain ? << Click Here >> for more details...
Technician A says the brake warning light is connected into
both the parking and service brake systems. Technician B
says the brake warning light will come ON only if the
service brake system fails. Who is correct?
- 2 Answers
- 7506 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin pulastya
Both are correct:
Technician A says: u can see the brake warning at both places,
that is possible.
Technician B says: warning will come at the both places if
"service brake system fails".
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
what is the difference between scaler and vector drive
how to turbine speed measurement?
How to Calibrate Flammable gas detector in field
Calibration procedure for water rotameters
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
key phaser where is use and work
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
What is 3 selection available when configure the burnout protection for controller
What is difference between Ionization heat and bimetallic heat
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
In apron feeder how TPH is calculated?
How is flow measured in square root?
