Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sri valli
The skin effect is the tendency of an alternating electric
current (AC) to distribute itself within a conductor so that
the current density near the surface of the conductor is
greater than that at its core.
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
what type of motor used to move a 1 ton gate? and relate ratings with load.
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
Explain thin film resistors and wire-wound resistors
what can be the causes of capacitor start motor having a higher current that its actual
What is the basic principle of welding process?
State kirchoff voltage law?
how we can calculate chiller required ampear?
why is control bus bi-directional?
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
If UG power cable both ends are to be earthed or what? If not why?
