Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karthik raman.b
it is generated in armature of DC motor the emf opposes the cause of it
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
there are cam operated switches - why we call cam operated , What is cam ?
size of condotory fron voltage level
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
What is the two pole structure?
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
for 750 kw LT load what will be the ht kva
How to measure the earth resistance value in a concrete pavement(flood light area)?
What does the term power factor shows?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
ult of expression 'document.FrmQF.myem
what is the concept of directional power?
At what speed an electric car can run with 2 HP motor of weighing 400 kg?
Control wiring of a dol starter for forward and backward
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
