what is the earthing condition between earth & neutral.
- 6 Answers
- 9398 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / nitin pulastya
Voltage difference b/w earth and neutral depends upon the leakage current and that depends upon supply voltage, load and earth pit connectivity(bcz in all same conditions except clay nature means alklye ness and dryness, the voltage diff. is always different) as i have seen in india as well as in Sudan and zambia.
this is not fixed b/w 2or3 volt. But it must be as low as possible by making perfect earth pit.
If the supply output is open ckt(zero leakage current)then no voltage will get but with supply as the load increases the voltage b/w earth and neutral will increase as the earth potential is zero (fixed).
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to decide and select the different earthing wire size for the different types of earthing
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
Is it possible to use a S1 duty class motor for crane application (S4)? If not, why?
how to flameproof electrical motor on the shaft?
what is the practical application of full adder circuit?
Why does the radius of armature is less than the radius of pole shoe?
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
What is advantages of VSCF wind electrical system?
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
Please send 110 kv sb station full single line drawing(sld)
Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
what is fault level of power system ?
what is servo motor & how does it work.
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
