Interested to Buy Any Domain ? << Click Here >> for more details...
why we use to transmit the power in three phases intead of
single phase ?
- 4 Answers
- 7195 Views
- I also Faced
- E-Mail Answers
Answer Posted / phanendra babu
there are so many reasons
1.generation is 3ph. so convertion is difficult
2.losses will be more in single phase system
3.equipment cost will be increased
4.copper cost increased for example for 3ph sys 3wires are
enough to transmit but for 3 single phases 6 wires are req.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What test must you do before powering up a circuit that you have been working on?
diff b/w normal grounding and resistance grounding
What is the tension required for the 25000 CFM AHU belt
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
what is a power factor?
what are the applications of PLC?
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
what is earth resistance? how to measured? and give values at power station and mcc area?
Why in ESP Positive earthed
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
Can i use the B-curve MCB instead of C-curve MCB
