Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the stanchan Height for installation of
Smoke detector & toxic gas detector in field,according to
qatar standard
- 2 Answers
- 6731 Views
- I also Faced
- E-Mail Answers
Answer Posted / m.v.ramesh
Ther is no countries standards for installation. Standards
are meant for type of industries, process and nature of
measurements.
1.a. Here for installing the smoke detectors there is no
particular height stndards. It has to be in the region of
smoke source or fire source. usually on the false sealings
in the buildings (height depends upon ceiling height).
(tendancy of smoke is raising to higher levels).
1.b. Under the false floors where the cables are laid in
the control rooms (Height depends upon False floor height).
In fields normally smoke detectors are not envisaged.
Because smoke is so thin and it may not raise verticcally
due to wind currents. Any how fire / heat detection is
suitable for detecting the fire hzards in the fields.
2. Ragrding toxic gas detectors again it has to be in the
region of gas emiting source or leakage sources,
ie, for example toxic gases emits from drainages or leak
from flange joints and piping components joints, so the
height of detector depends upon the height of the emiting
source or leackage source.
One has to study the civil/mech installations and decide
the height of the detectors.
Regards,
Maya Ramesh
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What are different types of valves?
In turbine, what does term CDP, NI, NH, HSSOC, means
what is wave length were using ?
What is the constant voltage unit?
How to calibrate Field bus transmitter? procedure ?
it is possible to check the fail safe condition in pressure transmitter. if possible how?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
What is the difference between PLC and DDC?
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
what is cold loop? difference between hot and cold loop?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
Explain an adaptive / self-tuning controller’s major draw card.
can u briefly explain aboutan aryton shunt multirange DC ammeter?
why we r opening HOT BYPASS valve during startup of a compressor?
