Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the value of earth resistance for an
instrumentation/electronic circuit? As per which IS/IEC
Code?
- 3 Answers
- 8096 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / deepak shrivastava
It should be less than or equal to 0.1 ohms.
| Is This Answer Correct ? | 22 Yes | 5 No |
Post New Answer View All Answers
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
ROC converges if poles and zeros lie inside a. Origion b. Z=1
Pl. brief about break-down maintenance of machine tool.
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
How to select a contactor? How many types of contactors are available
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
What happens if we run alternator on under frequency?
A low wet bulb temperature indicates
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
What is essential to prove safe isolation of electrical circuit?
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
