How can I zero check of wet leg type DP Tx ?
- 6 Answers
- 14817 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / id10t
Open bypass so HP=LP.
| Is This Answer Correct ? | 7 Yes | 12 No |
Post New Answer View All Answers
how to check earthing,what is minum ohms for proper earthing
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
What are different types of valves?
How is PH sensor works ?
In apron feeder how TPH is calculated?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
What is Erosion in a control valve?
What is instrumentation instrumentation engineering?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
What are advantages and disadvantage of the ac supply load cell?
