Interested to Buy Any Domain ? << Click Here >> for more details...
Dear All
please ive me ur ideas...
What is the major diff between cu conductors and Al
conductors ?
- 3 Answers
- 6154 Views
- MX Technology, I also Faced
- E-Mail Answers
Answer Posted / m s rana
Cu - Good conductor higher current rating
high current rating
less power losses
1 sqmm of cu can take current upto 4.5 amp
costly conductor
more heat resistive
stronger than Al
Al good conductor but not then cu
low current rating
more power losses than cu condctor
less heat resistive
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
why the pf of semiconductor device is improved the electrical devices
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
What is difference between slip rings and carbon burushes?
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
what is doubling factor in making current of a breaker?
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
how does high earth to neutral voltage affect electronic equipment?
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
what are the range of memory address in plc for L&T lx7 4A
