Interested to Buy Any Domain ? << Click Here >> for more details...
How would you supply a single house hold load from a 3-phase
supply coming out of a sub-station?
- 4 Answers
- 8681 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / azarudeen
3-phase supply from a sub-station will be 11kv or
6.6kv.This Voltage is stepped down to 440V by the
distribution Transformer,the distribution transformer has
Delta - Star connection, so in the output side you will hav
neutral line.
Now the phase voltage is 440 V.To supply house hold load we
connect the mains between a phase and neutral
| Is This Answer Correct ? | 62 Yes | 1 No |
Post New Answer View All Answers
what are the preventive maintanance actions taken for air circuit breaker? please answer me
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
Why ground terminal is used in pot meter 10k ohms
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?
what is the control circuit for operating the clean room air shower
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
low frequency protection why recomend?
What are the application of filter?
how many parameters can integrate with fire alarm basically ?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
what work will do diffrential realay DG set
single phase power supply give to separate one steel coup with water, what reaction create
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
